HomeVinyl Siding Replacement
Vinyl siding replacement for Lebanon and Boone County homes.
When vinyl siding fails, the color is rarely what gives it away first. It is a hem that snaps when you try to unhook it, a corner post pulling loose in wind, or a wall that has been letting water past it for years without anyone knowing. We tear the old siding down to the sheathing, look at what the wall behind it actually looks like, and rebuild from there instead of hanging new panels over an old problem.
Dirty vinyl and failed vinyl are not the same repair
A lot of vinyl siding that homeowners call us about does not actually need to be replaced. It needs a wash. Chalking, pollen film and general grime come off with the right pressure and detergent, and we will tell you that instead of quoting a tear-off you do not need.
Failed vinyl looks different once you know what to check. PVC gets more brittle every year it sits in UV, and the first place that shows up is the nail hem, the narrow lip along the top edge of each panel that hooks onto the course below it. On siding under about ten years old that hem still has enough flex to unhook cleanly for a repair. On older siding it snaps the moment you try to bend it, which is the real reason a one-panel repair on a fifteen-year-old wall usually turns into replacing the whole elevation: you cannot unlock the courses above the damage without cracking hems that are already brittle, and by that point the manufacturer has usually changed the panel profile or discontinued the color anyway.
Other signs point to replacement rather than a cleaning: panels that have rippled or warped, especially near windows with reflective glass that can bounce concentrated heat back onto nearby siding and soften it; panels that have come loose from the J-channel at corners; cracking that shows up after a hard freeze because cold-brittle PVC takes hail or a bumped ladder worse than it would in July; and fading so far gone that a new panel would obviously not match, even though the material underneath is otherwise sound.
What we actually find behind the panels
A tear-off is the only time anyone gets an honest look at how a wall has been managing water. Vinyl hides a lot. We have pulled siding off houses with a proper house wrap lapped correctly at every seam and window, and we have pulled siding off houses with felt paper stapled up decades ago that stopped doing its job long before the vinyl went brittle.
The two things we check every time are the water-resistive barrier and the sheathing underneath it. If the wrap is torn, under-lapped at seams, or missing around window and door flashing, water has likely been getting behind the cladding for years without ever showing up as a stain you could see from the driveway. The sheathing tells the rest of the story: OSB that has delaminated and gone soft, or a bottom plate that has been wicking moisture, usually shows up at the base of a wall or beneath a window before it shows up anywhere else. We photograph what we find before we cover anything, and if a section needs new sheathing, that goes into your quote as a named line item rather than a surprise on the invoice.
Where the rot traces back to gutters that have been overflowing onto the wall below for years rather than a housewrap failure, that is worth fixing at the same time. See gutter replacement for how we handle that half of the problem.
Vinyl options when we replace a wall
Not every vinyl panel is the same product wearing a different color. Thickness and backing change how it hangs and how it holds up.
| Option | Typical gauge | Best fit | Worth knowing |
|---|---|---|---|
| Builder-grade lap | .040–.042 in | Budget-conscious full replacements | Thinner panel shows waviness in low-angle sun and dents easier from a bumped ladder or small hail. |
| Standard lap | .044–.046 in | Most replacement jobs | The gauge we hang most. Enough rigidity to run straight over minor wall imperfections without extra furring. |
| Insulated vinyl | Foam-backed panel | Walls with visible waviness, or where a little added R-value matters | The foam backing telegraphs less of the wall's imperfections through to the surface. Panels cost more and are heavier to hang. |
| Dutch lap / shake profile | Same PVC, different shadow line | Gables, accent walls, homes wanting a shingle look | Priced closer to standard lap than most homeowners expect, since it is the same base material. |
Whatever gauge you choose, correct fastening matters as much as the panel itself. Vinyl siding is meant to move: panels expand and contract with temperature, and fasteners belong centered in the nailing slot with a small gap left under the head, never driven tight against the hem. Siding that was face-nailed or nailed too tight on its first installation cannot move the way it is designed to, and that is a common cause of buckling and oil-canning that has nothing to do with the panel's age.
How a siding replacement job runs at your house
- Free inspection. We check panel condition, hems, corners and moisture levels at the lowest courses and around penetrations, and tell you honestly whether you need a wash, a partial repair, or a full tear-off.
- Written scope. Panel gauge, color, trim and flashing details named, not left as an allowance.
- Delivery and staging. Material and dumpster placement scheduled ahead so your driveway isn't a surprise.
- Tear-off to the sheathing. Old panels, J-channel and trim come off, and the sheathing gets checked and photographed for rot or delamination before anything new goes on.
- House wrap and flashing. New water-resistive barrier lapped correctly at every seam and opening, with window and door flashing integrated properly. Any bad sheathing is replaced first.
- Trim, then panels. Corner posts, J-channel and starter strip go up plumb and level, then panels are hung with fasteners centered in the slot so the wall can expand and contract the way it's built to.
- Cleanup and walk-through. Magnet sweep, haul-off, and a walk around the house with you before the final invoice.
Warranty: what's covered on a siding job
We don't carry a separate workmanship warranty specific to siding installation. What we do have confirmed: a 2-year workmanship warranty on interior and exterior paint, a 2-year workmanship warranty on gutter and gutter guard installation, and a 5-year workmanship warranty on roofs. Any warranty on the vinyl siding itself comes from the manufacturer, not from us, and the terms vary by product line. See the full warranty breakdown for how our paint, gutter and roofing coverage works.
Recent replacements
What homeowners ask us about replacing vinyl siding.
Sometimes, if the siding is recent enough that the surrounding hems still flex without cracking and we can source matching stock. On anything older than about ten years the hems on the panels around the damage are usually too brittle to unhook cleanly, and the color or profile may no longer be made. We will tell you honestly which situation you're in before we quote anything.
Certain reflective, low-E window glass can bounce concentrated heat back onto nearby siding and soften the PVC enough to ripple it, even though the siding itself isn't in direct sun. Replacing that section without addressing the reflection angle can warp again. If it keeps happening in the same spot, a heat-tolerant material like fiber cement or LP SmartSide is worth considering for that section.
House wrap condition, sheathing for rot or delamination, and whether window and door flashing were lapped correctly the first time. If we find a section that needs replacing, we photograph it and give you the price before covering anything back up.
We install new house wrap on every tear-off. Once old wrap has been punched full of nail holes and exposed to the elements for a decade or more, it isn't doing its job even if it looks intact, and this is the one time in a wall's life that replacing it is easy.
Newer panels are less brittle than old, sun-baked siding, but vinyl doesn't carry the same impact ratings that some roofing shingles do, and cold weather still makes it more prone to cracking on a hard direct hit. If a storm is what damaged your siding, it's worth a conversation about whether it's a covered claim. See insurance roofing for how we handle that process.
Yes, across Boone County and the surrounding towns, including Zionsville. Older housing stock there tends to show the same nail-hem and house-wrap issues we see everywhere else in the area, just on a different mix of home styles.
Within 24 business hours, and usually sooner. Calling gets you a person fastest during office hours, Monday to Friday, 9:00am to 5:00pm.
Yes to both. Siding replacement jobs start with 50% down, which orders material and holds your spot on the schedule, and the balance is due once the job is finished and you have walked it with us. Financing is available on larger siding projects, so ask us about options when we come out.
Where to next?
We will tell you if it needs a wash, a repair, or a real tear-off.
No charge, no obligation. If your siding just needs cleaning instead of replacing, that is what we will tell you.
(765) 335-6475Monday to Friday, 9:00am–5:00pm · or text us
Book online in about a minute.
Pick a day and time that works for you and it goes straight onto our schedule. No waiting on a callback.
Get a Free Estimate- Free on-site look, no charge either way
- You keep every photo we take
- We answer every call and text within 24 business hours